TECHVOX 103X

• All substances that may prevent adhesion on the surface must be cleaned. Otherwise, negative results may occur.
• The areas to be applied must be repaired.
• To achieve a better bonding surface with the flat side of the trowel, the mortar should be combed according to the size of the selected tile after being spread on the surface.
• For the application of covering materials sized 40x40 cm and larger, combined bonding methods should be preferred in areas with heavy pedestrian and load traffic.
• The tiles should be applied within 20 minutes on the combed mortar. Adhesion should not be performed on the mortar under unsuitable environmental conditions such as high temperature, low humidity, or wind; the mortar should be removed from the surface.

• Ceramic, travertine, natural stone
• Provides excellent results for the application of materials such as mosaic and decorative brick on vertical and horizontal surfaces like bathrooms, kitchens, concrete, plaster, and screed.
• Suitable for glass mosaic cladding on exterior and interior facades, filling joints, and glass brick applications.
• Does not slip, easy to use.
• Before ceramic adhesive applications on existing ceramics, the surface must be primed with 133P Smooth Surface Primer.

Pour 6.5-7.5 liters of clean water into a clean, round-shaped container, and gradually add the 25 kg powder product while mixing until a homogeneous appearance is achieved without lumps. The mixture should be made using a low-speed mixer. Fresh mortar should be mixed again before application after resting for 5 minutes.

Areas of Use

• Ceramic, travertine, natural stone
• Provides excellent results for the application of materials such as mosaic and decorative brick on vertical and horizontal surfaces like bathrooms, kitchens, concrete, plaster, and screed.
• Suitable for glass mosaic cladding on exterior and interior facades, filling joints, and glass brick applications.
• Does not slip, easy to use.
• Before ceramic adhesive applications on existing ceramics, the surface must be primed with 133P Smooth Surface Primer.

• Avoid application below +5 °C and above +35 °C.
• After application, protect from direct sunlight, strong wind, high temperatures (above +35 °C), rain, and frost.
• Do not add powder to mortar that has exceeded its usage period.

• It is recommended to use rubber gloves during product application.
• The product should not be inhaled directly. A dust mask should be used if necessary.
• Products should be stored out of reach of children.
• Consult a doctor if necessary.
• R38 Irritates skin.
• R41 Risk of serious eye damage. Contains Chromium VI. Allergic reactions may occur.
• R43 May cause sensitization by skin contact.
• Keep out of reach of children.
• S22 Do not breathe dust.
• S24/25 Avoid contact with eyes and skin.
• S26 In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.
• S37/39 In case of ingestion, seek medical advice immediately, showing the product container and label.