REPAIRVOX 15R

Surface Preparation

• The hardness, water absorption, and soundness of the application surface should be checked in advance.
• If the surface has high water absorption, VOX Waterproofing additive should be used to eliminate water absorption.
• Voids and areas requiring repair on the surface should be repaired beforehand.
• Weak substrates such as cracked plasters or surfaces that cannot bear their own weight, as well as mortar and cement residues, should be scraped off.
• Surfaces must be free from dust, dirt, debris, formwork oil, etc.

Application

• The mortar is spread onto the surface with a steel trowel.
• If no plastering is to be done, after moistening the area to be repaired, apply the mortar in a single layer at 0.5 cm thickness.
• Wait approximately 3-4 hours between coats depending on ambient conditions, and if necessary, apply the second coat at the same thickness.
• The application thickness on the repair area should not exceed 1 cm.
• If the crack width is less than 2 mm, the mortar should be applied with a brush.
• The surface should be finished with a damp sponge.

Areas of Use

• On interior and exterior surfaces
• In closed parking garages and vertical ramps,
• Aircraft hangars and mechanical workshops
• For repairing plaster cracks and for renovation and refurbishment works in interior and exterior spaces.
• In large reinforced concrete structures such as bridges and dams.

4-7 liters of clean water is poured into the mixing container and the mortar is gradually added while mixing until a homogeneous consistency is achieved. Use a low-speed mixer for mixing. Mixing at high speed prevents achieving a homogeneous consistency. After waiting 5 minutes for maturation, mix again for 1 minute and the mortar is ready for use.

1. Avoid application below +5°C and above +35°C.
2. After application, protect from direct sunlight, strong wind, high air temperature (above +35°C), rain, and frost.
3. Do not add powder to mortar whose pot life has expired.
4. Mix the material only with a mixer with a maximum of 120 rpm.

1. It is recommended to use rubber gloves during product application.
2. Do not inhale the product directly. Use a dust mask if necessary.
3. Keep products out of reach of children.
4. Consult a doctor if necessary.
5. R38 Irritating to skin.
6. R41 Risk of serious eye damage. Contains Chromium VI. Allergic reaction may occur.
7. R43 May cause sensitization by skin contact.
8. Keep out of reach of children.
9. S22 Do not breathe dust.
10. S24/25 Avoid contact with eyes and skin.
11. S26 In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.
12. S37/39 If swallowed, seek medical advice immediately and show the container or label.