FLEXVOX 107 FX C2TES1

• The mixture should be prepared with a low-speed mixer. No additives that are not specified in the application instructions should be used.
• The dusty surface behind the ceramic should be wiped with a clean cloth.
• The mortar should be mixed with a medium-speed mixer for 3 - 5 minutes until it is ready.
• The prepared mortar should rest for 5 - 10 minutes. It should be mixed again for 2 - 3 minutes before starting the application.
• To achieve better adhesion, the flat side of the trowel should be used to prepare the mortar on the surface, and then the notched side of the selected trowel should be used according to the tile size.
• The tiles applied with force on the notched mortar should be adhered within 30 minutes. Adhesion should not be performed on the mortar under unsuitable environmental conditions such as high temperature, low humidity, and wind; the mortar should be removed from the surface.

• Used for bonding floor and wall ceramics to concrete surfaces, plaster, screed, and wall surfaces horizontally and vertically.
• Used for bonding pool ceramics in indoor and outdoor environments.
• Suitable for wet areas such as pools, water tanks, baths, and bathrooms.
• Has high adhesion stability.
• Does not slip, easy to use.
• The surface should be primed with 133P Non-Slip Surface Primer before ceramic bonding applications on existing ceramic surfaces.

Pour 6.5-7.5 liters of clean water into a clean, round-shaped container, and gradually add 25 kg of powder product while mixing until a homogeneous appearance is achieved without lumps. The mixture should be prepared with a low-speed mixer. Fresh mortar should be mixed again before application after resting for 5 minutes.

• Avoid application below +5°C and above +35°C.
• Pay attention to the amount of water remaining in the mortar.
• Do not add powder and water to the mortar that has exceeded its usage period.
• If there is crusting in the material, re-wetting is not recommended.

• It is recommended to use rubber gloves during product application.
• The product should not be inhaled directly. A dust mask should be used if necessary.
• Products should be stored in places out of reach of children.
• Consult doctors if necessary.
• R38 Irritates skin.
• R41 Risk of serious eye damage Contains Chromium VI. Allergic reactions may occur.
• R43 May cause sensitization by skin contact.
• Keep out of reach of children.
• S22 Do not breathe dust.
• S24/25 Avoid contact with eyes and skin.
• S26 In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.
• S37/39 In case of ingestion, seek medical advice immediately, showing the product container and label.