HYDROVOX 432
Elastomeric Acrylic Resin-Based, Fiber-Added Elastic Waterproofing Material
- Packaging
- 5 kg, - 15 kg plastic bucket
- Application area
- Water tanks, swimming and decorative pools, terraces
- Consumption
- 1.5 kg/m²
Properties
- Resistance to full impact
- Applied directly with a brush or roller.
- Effective water vapor permeability.
- Can be painted over.
Acrylic-based, elastic, ready-to-use, single-component liquid plastic coating and waterproofing material.
Surface Preparation
- Ensure that the hardener used in the floor covering is completely dry and check manually.
- Surface Quality: Surfaces must be clean, smooth, solid, and free from any dust, oil, dirt, rust, mold oil, detergent, and similar substances that may prevent adhesion.
- On hot surfaces, the surface should be cooled with water without exception.
- Fresh application layers must be protected from rain and frost for at least 24 hours.
- The hardness, water absorption, and strength of the surface to be applied should be checked in advance.
- Before application, HYDROVOX diluted with water at a ratio of ¼ by volume should be applied as a primer on the surface.
- Apply 3 coats horizontally and 2 coats vertically with a brush or roller. The thickness should be 1-1.5 mm.
- The waiting time between layers varies depending on environmental conditions but is 4 hours. Application should not be done in very high temperatures, directly exposed to sunlight, in very windy, rainy, or frost-risky weather.
- Use a hedgehog roller to release gas. Texturing is required on very smooth surfaces.
- Water tanks, swimming and decorative pools,
- Sloped terrace roofs,
- On the exterior facades of buildings,
- On sloped roofs and terraces covered with concrete, plaster, cement board, galvanized, zinc, aluminum, PVC, polyester, and wood,
- Wet areas such as bathrooms, toilets, balconies,
- On the exterior facades of silo storage and buildings,
- Used as an elastic waterproofing material on reinforced concrete, galvanized sheet, polyurethane foam, zinc, PVC gutters, and hidden drainage surfaces,
- On surfaces such as stone, brick, tile, and decorative coatings,
- On old coatings, finished membranes, or asphalt-covered surfaces.
- Used to extend the life of waterproofing and provide energy savings.
Ready to Use.
After mixing with a low-speed mixer, apply 3 coats horizontally and 2 coats vertically with a brush or roller.
The total thickness of the application should be 1.0-1.7 mm.
The second coat should be applied after the first coat is completely dry.
- Avoid application below +5°C and above +35°C.
- After application, protect from direct sunlight, strong winds, high temperatures (+35°C and above), rain, and frost.
- It is recommended to use latex gloves during product application.
- Products should be stored out of reach of children.
- Consult a doctor if necessary.
- R38 Irritates skin.
- R41 Risk of serious eye damage Contains Chromium VI. Allergic reactions may occur.
- R43 May cause sensitization by skin contact.
- Keep out of reach of children.
- S24/25 Avoid contact with eyes and skin.
- S26 In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.
- S37/39 In case of ingestion, seek medical advice immediately.