PROVOX CRX 869
2 in 1 multipurpose ceramic adhesive. It is an S2 class highly flexible, high-performance, slip-reduced, long working time, cement-based adhesive mortar that provides waterproofing.
- Packaging
- 25 kg kraft bag
- Application area
- Interior and exterior facades, walls and ceilings
- Consumption
- Approximately 1.5 kg/m²/mm
- Complies with TS EN 12004 C2TES2P2 class C: Cement-based 2: High performance
- T: Slip-reduced
- E: Extended working time
- S2: Highly flexible
- P1: Plywood adhesive
Features
- 2 in 1 multipurpose
- Ceramic adhesive
- Waterproofing mortar
- Highly flexible
- Suitable for all types of large-sized stone and ceramic
- Pool, hamam, sauna, bathroom, terrace
Product Description
2 in 1 multipurpose ceramic adhesive. It is an S2 class highly flexible, high-performance, slip-reduced, long working time, cement-based adhesive mortar that provides waterproofing.
Surface Preparation
• The surface must be clean, dry, smooth, and solid, and any plaster thinner than 3 mm on the surface must be completely removed.
• Porous surfaces should be wetted and waited until the water layer disappears, keeping the surface damp.
Surface Preparation
- The surface must be clean, dry, smooth, and solid, and any plaster thinner than 3 mm on the surface must be completely removed.
- Porous surfaces should be wetted and waited until the water layer disappears, keeping the surface damp.
Application
- The mixture should be prepared with a low-speed mixer. No additives not specified in the application instructions should be added or used.
- The prepared mortar should rest for 5-10 minutes. It should be mixed again for 2-3 minutes before starting the application.
- To achieve a better bonding surface, the mortar should be combed according to the size of the selected trowel after spreading it on the surface.
- For the application of covering materials 40x40 cm and larger, combined bonding methods should be preferred in areas with heavy pedestrian and load traffic.
- Tiles applied on combed mortar should be adhered within 20 minutes. Adhesion should not be performed on the mortar under unsuitable environmental conditions such as high temperature, low humidity, or wind; the mortar should be removed from the surface.
- For the application of covering materials such as ceramic, natural stone, travertine, decorative brick, granite, porcelain ceramic, clinker, and cotto in both indoor and outdoor environments, horizontally and vertically
- In wet volume areas such as pools, hamams, spas, saunas, and water tanks, for ceramic and mosaic applications,
- For ceramic covering on old ceramic and granite,
- In wet volume areas such as pool water tanks
- In areas with temperature changes such as cold storage, shock facilities, exterior of ovens, and underfloor heating systems
No content has been added for this section yet.
- Avoid application below +5 °C and above +35 °C.
- After application, protect from adverse weather conditions such as direct sunlight, strong wind, high air temperature (above +35 °C), rain, and frost.
- Do not add powder to mortar that has exceeded its usage period.
- It is recommended to use rubber gloves during product application.
- The product should not be inhaled directly. A dust mask should be used if necessary.
- Products should be stored out of reach of children.
- Consult a doctor if necessary.
- R38 Irritates skin.
- R41 Risk of serious eye damage. Contains Chromium VI. Allergic reactions may occur.
- R43 May cause sensitization by skin contact.
- Keep out of reach of children.
- S22 Do not breathe dust.
- S24/25 Avoid contact with eyes and skin.
- S26 In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.
- S37/39 In case of ingestion, seek medical advice immediately, showing the product container and label.