FLEXVOX 105 FX
C1 & S1 Class, Water Repellent, Super Flexible, High Performance and Stable Adhesive
- Packaging
- 25 kg kraft bag
- Application area
- Interior and exterior facades, wall, floor, and ceiling
- Consumption
- 85-100 sqft / 6-8 m²
S1 Class flexible, high-performance, reduced slip property, cement-based adhesive mortar suitable for underfloor heating, bathrooms, and wet areas with a long working time.
Areas of Use
- Used for bonding ceramic tiles to concrete surfaces, plaster, screed, and wall surfaces both horizontally and vertically.
- Used for bonding pool ceramics in indoor and outdoor areas.
- Used for wet areas such as pools, water tanks, baths, and bathrooms.
- Has high adhesion stability.
- Does not slip, easy to use.
- Before ceramic bonding applications on existing ceramic surfaces, the surface must be primed with 133P Smooth Surface Primer.
- The mixture should be prepared with a low-speed mixer. Any additives not specified in the application instructions should not be used.
- The dusty surface behind the ceramic should be wiped with a clean cloth.
- The mortar should be mixed with a medium-speed mixer until it reaches a ready state for 3 - 5 minutes.
- The prepared mortar should rest for 5 - 10 minutes. It should be re-mixed for 2 - 3 minutes before starting the application.
- To achieve better adhesion, the mortar should be prepared with the flat side of the selected trowel according to the surface, and then combed with the notched side of the trowel suitable for the tile size.
- The tiles applied with force on the combed mortar should be bonded within 30 minutes. Bonding should not be performed on the mortar under unsuitable environmental conditions such as high temperature, low humidity, and wind; the mortar should be removed from the surface.
- Used for bonding ceramic tiles to concrete surfaces, plaster, screed, and wall surfaces both horizontally and vertically.
- Used for bonding pool ceramics in indoor and outdoor areas.
- Used for wet areas such as pools, water tanks, baths, and bathrooms.
- Has high adhesion stability.
- Does not slip, easy to use.
- Before ceramic bonding applications on existing ceramic surfaces, the surface must be primed with 133P Smooth Surface Primer.
Pour 6.5-7.5 liters of clean water into a clean, round-shaped container, and gradually add the 25 kg powder product while mixing until a homogeneous appearance is achieved without lumps. The mixture should be made with a low-speed mixer. Fresh mortar should rest for 5 minutes.
After resting, it should be re-mixed before application.
No content has been added for this section yet.
- It is recommended to use rubber gloves during product application.
- The product should not be inhaled directly. A dust mask should be used if necessary.
- Products should be stored out of reach of children.
- Consult a doctor if necessary.
- R38 Irritating to skin.
- R41 Risk of serious eye damage. Contains Chromium VI. Allergic reactions may occur.
- R43 May cause sensitization by skin contact.
- Keep out of reach of children.
- S22 Do not breathe dust.
- S24/25 Avoid contact with eyes and skin.
- S26 In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.
- S37/39 In case of ingestion, seek medical advice immediately, showing the product container and label.